How to Reprogram Clicker Garage Door Keypad

How to Reprogram the Clicker Garage Door Keypad

1. Be sure to clear the garage door area of any obstructions.
2. Locate the LEARN button on the door control.
3. Press the LEARN button twice.
4. Enter a 4-digit PIN of your choice on the keypad, and press ENTER.
5. The opener lights will blink, indicating the PIN programming is complete.

Relevant: How to Program Clicker Garage Door Opener

How to Reprogram the Clicker Garage Door Keypad without Code??

You may have misplaced the old keypad and need to replace it. So, how do you re-program the keypad on your clicker garage door? Alternatively, your old keypad may require reprogramming, but you have forgotten the code for the key. Now you have the option of resetting the keypad without having to input the code. Clicker garage door keypad forgot code is a common issue. So let’s get down to business.

Below are the steps on How to Reprogram the Clicker Garage Door Keypad without Code??

Step 1

Reach the garage with a ladder. You will need to reach the motor unit of the garage door opener. Moreover, the location of the motor unit is on top of the garage door opener. Take your ladder there to reach your designated point.

Step 2

Search for the learn button after you reach the top. You will find the learn button near the motor unit. Search around there. Now press and hold the learn button. Furthermore, Wait until the light stops illuminating. You have successfully wiped your previous saved code. Now the system has no passcode.

Step 3

Tap the learn button again. The action will make the light illuminate again. Reach your keypad. Now enter your desired code. Remember to put a code that cannot the thieves will not be able to guess easily. Moreover, The light near the motor unit will blink. This blink indicates that the system has accepted your code.

Now tap the learn button. Tapping the learn button should make the door open for you. 

What if your garage door doesn’t have a keypad?

There’s a chance your garage door doesn’t have a keypad. Don’t be alarmed! We’ve got your back. Remove the remote cover with your remote. The interior of the remote may be seen by opening the lid. Some switches are the first thing you’ll notice. The code is represented by the switches. The code you previously used.

Now you can move the switches around to make the code you want. Your garage door opener will need to be examined. There are a few switches in that area. The code pattern on the switches will match the code pattern on the remote. Adjust the switches to match the remote’s coding.

Finally, replace the remote cover in its original location. If the solution works, test your remote. The door should be opened.

What if a remote doesn’t work?

There are some obvious reasons why your remote doesn’t work. The first cause may be that your remote battery is dead. Go to a shop or charge your remote and try again! Another reason can be due to corroded contacts. Polish the connections to make them work. Another reason can be your door was locked manually. If so, then check it. Moreover, if the problem continues to occur, replacing your remote will be a wise decision.

Find Here: How to reset a garage door keypad without the enter button